After downloading Extract it also by 7-Zip, Winrar or any other extractor. As mentioned above, download “Pacote de Config”. After writing process finished, then you should get the Successful message like a shot below. Wait for Win32DiskImager to complete the Writing process to 100%. So after selecting the image and USB, click Write then it will show warning messages, click Yes to begin the Bootable USB Installer process. ) then select Install macOS Sierra and click Open. After selecting a device, click on the folder icon beside the device selection option and browse the macOS Sierra image file that you downloaded from the link above. Run Win32DiskImager as admin and select your USB flash drive that wants to use as a bootable device for macOS Sierra 10.12. When the installation process completed, click Finish to exit the setup wizard. Now Install Win32 DiskImager, open the Win32DiskImage.exe file then click next, next couple of times and other necessary installation steps, like license agreement. After downloading macOS Sierra image file from the link below Extract it with 7-Zip, Winrar or any other extractor. Step #1. Firstly, download the following materials from the link below.ĭownload macOS Sierra image file (Updated) Download Win32DiskImager Download “Pacote de config” Note: This method works on Windows 7/8/10, and it’s not the TransMac process.

The download process is a little bit complicated if you are not known to mega because you have to download it from there, also the credit goes to a Brazilian Hackintosh group. To create a Bootable USB Installer, you need to download macOS Sierra image file from the link below and other data that mentioned in the download section with an 8 or higher USB flash drive. Create macOS Sierra Bootable USB Installer on Windows 10 #

Make a windows 10 bootable usb on mac